Increase the performance of your engine with Fast Toys ported MAF ends! These high flow components replace the restrictive factory aluminum inner and outter MAF ends. Working in conjunction with your factory MAF electronic sensor, our MAF ends increase airflow potential to over 1000 CFM!

Just look at the picture comparing the factory aluminum MAF end to our high flow design! The difference is obvious.

Featuring a composite plastic construction, these ported MAF ends remove the restrictive center dividers and screen that are present in the factory design. In addition, our MAF ends will not heat soak which is a common problem with the factory aluminum design. Cooler air equals more power!

Unlike other brands, these shells are formed in one piece molds which mean that the inside of the shells are smooth for the best possible airflow. On our 1998 LS1 Camaro test vehicle, the ported MAF ends were worth a solid one MPH in the quarter mile!

Installation:
The MAF ends take less than 5 minutes to install and only require a couple of screwdrivers. No modification is required to any factory components so you can go back to stock at any time.