|RPMSpeed does not recommend Stage 4 clutches for street use because of their aggressive nature. A rigid disk and carrier are used in combination with your choice of Kevlar, carbon or ceramic pads. Comes with High-clamp pressure plate, 2-piece rigid disc, TO bearing, pilot bearing and tool.
From SPEC is their new aluminum pressure plate. This option replaces the old "Lightweight Pressure Plate" option where they drilled holes in the outside of the pressure plate to reduce rotating mass. The benefit of the aluminum pressure plate is comparable to gains from a lightweight flywheel, and in most cases is less costly.
For years lightweight flywheels have been used to transfer energy from an engine to the ground more efficiently, resulting in horsepower and torque gains, quicker revving and less internal engine wear. The SPEC aluminum pressure plates offer the same benefits, and the reduction in mass is more effective since the pressure plate extends further from the crank flange.
These plates can be used with an OE flywheel or in conjunction with a lightweight flywheel for a more drastic improvement. Drivability is virtually unchanged, and the aluminum plates offer the same high clamp loads, and in some cases more clamp load, than the standard steel SPEC high performance pressure plates. SPEC uses only aerospace quality aluminum and fasteners and most SPEC aluminum pressure plates carry SFI certification. Make your selection below: